Hobby & Collectables store with the theme Wires, plugs, switches

With retaining nut 2A, 250V (VDE) DC Base dimensions: 22.5 x 15 mm Thread length: 12 mm

A pack of 12 pieces

Single action button for uncoupling tracks.Use this unit wherever power must be supplied for a short time. The individual buttons are electrically insulated and thus they can operate different power circuits.

Change over button with feedback.

Change over button with feedback for single-slip turnouts and symmetric three-way turnouts. These two turnout designs require – if properly controlled – connections for the four possible turnout positions. The switch 10526 offers a definite control of the three permissible turnout settings. Additional switches can be connected side-by-side.

With built-in reed switch, to be actuated by means of a 42256 magnet.This potential-free switching contact can be installed at any point of a track layout. The size and colour of the sleeper goes with the ROCO LINE-track, thus camouflaging the contact.Can also be used as feedback-momentary contact along with feedback module 10787 or detector 10808.

8-pole connector, e.g. for 10777.

Single pole, this contact is slipped on between the tie strip and the rail.

This rectifier is for bridging opposite direction operation for signal blocks, reverse loop safeguarding, etc. It is not suitable for Selectrix operation!

2-pole connecting cable with mounted rail clips for ROCO LINE tracks.This cable has no interference suppressor units (EMC) and may only be used for halting sections in front of signals etc. Please use 42421/42521 as the feeder track.

To insulate joints and to mark cables. Contracts strongly under influence of heat, hot air.

To insulate joints and to mark cables. Contracts strongly under influence of heat, hot air.

A package comes with 10 pieces.

The feeder wire set comes with interference suppression and overload protection. It includes a circuit board with spade connectors for C Track and a red and a brown feeder wire. One feeder wire set is needed for each conventional track circuit. One 74046 feeder wire set should be installed in each track power circuit to protect against possible radio and television interference caused by locomotives in operation. This feeder wire set also offers effective protection against overloads and short...